JavaScript är inaktiverat. För en bättre upplevelse, vänligen aktivera JavaScript i din webbläsare innan du fortsätter.

Svara på tråd

Meddelande: <blockquote data-quote="Themasterpiece" data-source="post: 1094050" data-attributes="member: 159333">Even without a template you can do the following:1. Mount the Beast heel insert into your boots.2. Mark a centre line down your ski (on masking tape)3. Clip the boot toe into the toe piece and slide the heel section into the boot heel (brakes held up with a rubber band). So it’s fully assembled. Position the centre line of your boot where you want it on the ski. Mark the position of the toe piece.4. Make sure holes are properly centred and perpenducular to the centre line. Install the toe piece on the ski. 5. Do the same as 3. above. Mark the position for the heel piece.4. Again make sure holes are centred and perpenducular to the centre line. Install the heel piece on the ski. 5. Adjust the heel piece with the screw for 0.2mm gap to the boot (slide a slip of thick paper into the gap).6. Trim any rubber off your boots that interfer when in walk mode.Do a mock up on a piece of wood first. Measure twice, cut once <img src="https://cdn.jsdelivr.net/joypixels/assets/8.0/png/unicode/64/1f642.png" class="smilie smilie--emoji" loading="lazy" width="64" height="64" alt=":)" title="Smile    :)"  data-smilie="1"data-shortname=":)" /></blockquote>